Tilton Box Beam Coffered Ceiling Systems are priced and packaged as an All-Inclusive product that contains some or all of the following pre-assembled and individual components (depending on the design) to allow you to complete each installation without the need to source or purchase ANY additional materials:
Included as fully pre-assembled units with beam walls and crown moldings pre-installed. The Coffer Modules are fastened directly to the ceiling joists or structure with screws and without the need for any trimming or cutting.
Included in 8ft lengths to be square cut to fit. The Nailer Boards are fastened to the perimeter walls of the room with nails or screws during the installation process.
Included in 8ft lengths to be square and/or miter cut to fit. The Beam Boards are fastened to the bottom edges of the Coffer Modules with nails during the installation process.
Included in 8ft lengths to be square and/or miter cut to fit. The Perimeter Moldings are fastened to the perimeter walls of the room with nails during the installation process.
Included in quantity and with the required driver bit(s). The leveling lag screws are used to secure the Coffer Modules to the ceiling joists or structure and adjust them for level during the installation process.
The Box Beam Ceiling System Installation Manual may be viewed and/or downloaded HERE
Also see the Anatomy of the Box Beam System for additional info on how the above described components are used together to create the finished Box Beam Ceiling Treatment
CAD drawings are provided at no additional charge upon receipt of deposit for your order. However, if the drawings are needed prior to placing your order an up-front drafting fee will be required. Any up-front drafting fees will be applied towards the total cost of your ceiling system at the time of order, but are otherwise non-refundable.
All of our Ceiling Treatment Products are designed by and for the PROs, yet easy enough for DIYers to order and install
EASY TO DESIGN | SIMPLE TO INSTALL | BEAUTIFUL TO BEHOLD